Watts Premier FILTER-PURE Manuel d'utilisateur télécharger pdf (Page 9)

Place a towel under the lter module to catch any excess water that

may drip out from the lters during the changeover.

Step 1

Your system is equipped with valved heads which will automatically turn off the

water supply to each lter when the lter is released, thus you do not need to turn

off the incoming water supply at the Adapt-a-Valve. The faucet must be off when

lters are replaced. To make the removal of the lter cartridges easier, the heads

& cartridges may be swiveled up to 90 degrees as shown in the pictures below.

Step 2

To install a lter cartridge: Remove the seal cap and insert

the cartridge into the valved head until you hear an audible “click”

(the button does not need to be pressed to install new lters).

Step 3

To remove a lter cartridge: Push & hold the button on the

valved head above the lter. Pull cartridge downward (from the

head) to remove. Release button and discard old lter.

Changing The Filter Cartridges

√ One sediment lter (Red Label P/N: 105311)

√ One LVOC Block (Blue Label P/N: 105371)

Replace:

6 Month System Maintenance

√

One sediment lter (Red Label P/N: 105311)

√ One LVOC Block (Blue Label P/N: 105371)

√ One UF Membrane (Purple Label P/N: 105321)

Annual System Maintenance

Replace:

Note:

If the new lter cartridge won’t snap in easily or pops off it may be

due to high incoming water pressure. Relieve pressure to the system by

turning off the water supply using the adapt-a-valve and then install the

cartridge. Once the cartridge is seated, turn the water supply back on to

your unit.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Watts Premier FILTER-PURE Manuel d'utilisateur Page 9